Stiga TRE 0801 - Replacement of Starting Motor

Release 00 - 03/2018
pag. 20
Engine TRE 0701-TRE 0702-TRE 0801
Service manual
8 - Verify the condition of the brushes and,
using a gauge, measure (15) the length which
should be between 8.5 and 12 mm. If the length is
shorter, the brushes must be replaced as indicated
below.
9 - Insert new brushes in the appropriate seats and
secure with the screws (12).
Pay particular attention to the correct positioning
of the brushes and springs.
10 - Re-assemble the starter motor, securing the
screws (11) to the indicated couple.
11 - Fix the starter button with the screws (9) to the
indicated couple and ret the ywheel (8).
12 - Ret the tape reel and x the screws to the indi-
cated couple [ 9.3] execute the regolation in
accordance with the regolation air gap [ 9.2].
13 - Ret the fan and x the nut (3) to the indicated
couple, and the cowl.
6.2. Replacement of starting motor
Perform operations indicated in [
6.1].
Tightening torques
3 Flywheel xing nut 110-120 Nm
7 Coil xing screw 8-12 Nm
9 Fixing screw starting motor 22-30 Nm
11 Starting motor screw 8-12 Nm
Technical information
Brushes length 8,5÷12 mm
Air gap tape reel/ywheel 0,25-0,40 mm
Special equipment
15 Gauge
6. STARTING SYSTEM
14
14
15
INDEX
<< BACK >>