Chain Brake
• Take the brake band (1) out of the
sprocket cover and detach it from
the bell crank (2) at the same time.
• Fit lever with pivot pin and press it
home as far as stop.
• Slide bell crank into end of hand
guard. The long arm (1) of the
bell crank must point to the hole
(2)
• Locate the hand guard and bell
crank on the pivot pins.
• Now press the flat spring (1)
down and push the hand guard
and bell crank fully home.
• Fit flat spring (1) in position.
• Ease the hand guard (1) and bell
crank (2) off the pivot pins.
• Pull the bell crank out of the
hand guard and then take the
hand guard out of the sprocket
cover.
• Remove lever (1) with pivot pin
and flat spring (2).
• Inspect parts. Replace any worn
or damaged parts.
• Fit hand guard in the sprocket
cover.
• Attach brake band to the bell
crank.
To Next Page
Loading...
