Stihl 020 T

STIHL 020 T 41
8.5 Contact Springs
8.4 Switch Shaft
8.3 Interlock Lever/
Throttle Tri
gg
e
r
• Remove the choke/throttle rod –
see 8.2.
• Take out the interlock lever.
• Remove the throttle trigger –
see 8.3.
• Pull out the switch shaft.
• Remove the front upper annular
buffer - see 7.
• Pull out contact spring (1) for
ground wire (2).
• Disconnect the ground wire.
• Pull the short circuit wire off the
contact spring.
• Push the contact spring (2) slightly
to one side and fit the switch shaft
(1).
• Install the throttle trigger –
see 8.3.
Note: Lubricate switch shaft with
grease - see 11.2.
• Remove the throttle trigger.
• Take the torsion spring off the
throttle trigger.
Assemble in the reverse sequence.
• Pull out the contact spring.
Assemble in the reverse sequence.