Stihl 020 T

STIHL 020 T 31
5.3 Ignition Lead5.2 Ignition Plug Terminal
• Coat end of the ignition lead
(about 20 mm(3/4") with oil.
• Fit spark plug terminal over the
ignition lead.
• Use suitable pliers to grip the end
of the ignition lead inside the spark
plug terminal and pull it out.
• Remove the ignition module -
see 5.4.2.
• Remove the flywheel - see 5.5.
• Remove the chain sprocket
cover.
• Pull terminal (1) off the spark
plug (2).
• Pull the lead back into the
terminal so that the leg spring
locates properly inside it.
• Fit terminal on spark plug and
refit chain sprocket cover.
• Unhook the leg spring from the
ignition lead.
• Slip the spark plug terminal off
the lead.
• Use a suitable pair of pliers to grip
the leg spring and pull it out of the
spark plug terminal.
• Pinch the hook of the leg spring
into the center of the lead, i.e.
about 15 mm (⅝") from the end
of the lead.
• Remove the oil pump - see 9.3.1.
• Pull terminal off spark plug.
• Pull ignition lead out of crankcase.
• Remove the spark plug terminal -
see 5.2.
• Cut new ignition lead to length
(see parts list or cut to same length
as old lead).