Stihl 020 T - Double Lever (Choke;Throttle) Service; Front Handle Service

STIHL 020 T 42
8.6 Double Leve
r
(Choke/Throttle)
8.7 Front Handle
• Remove the choke/throttle rod –
see 8.2.
Choke double lever:
• Pull out the double lever.
• Pull out the double lever.
Assemble in the reverse sequence.
• Remove the switch shaft –
see 8.4.
• Take out the upper front handle
mounting screw.
• Take out lower front handle
mounting screw.
Note: Note that short choke rod
must be fitted in the upper hole.
Throttle double lever:
• Remove the carburetor -
see 10.2.1.
• Disconnect short throttle rod.
• Pull front handle out of handle
housing.