EasyManua.ls Logo

Stihl MSA 161 T - User Manual

Stihl MSA 161 T
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
STIHL MSA 161 T
Instruction Manual
Notice d’emploi

Table of Contents

Questions and Answers

  • S
    Scott FrederickSep 23, 2025
    What to do if there is a fault in the Stihl Chainsaw battery?
    • V
      vhunterSep 23, 2025
      Engage the chain brake, remove and refit the battery. Disengage the chain brake. Switch on the saw. If 4 LEDs continue to flash red: Do not use the battery and contact your STIHL dealer for assistance.
  • V
    Vincent WallaceAug 25, 2025
    What to do if my Stihl chainsaw cuts out while I'm using it?
    • V
      Vincent WebbAug 26, 2025
      If your Stihl chainsaw cuts out during operation, it could be due to the chainsaw being too hot; allow it to cool down. Alternatively, there may be an electrical fault; in that case, engage the chain brake, remove and refit the battery, and switch on the chainsaw.
  • S
    Sarah KleinAug 27, 2025
    Why does my Stihl Saw cut out during operation?
    • J
      joshua36Aug 27, 2025
      Your Stihl Saw might be cutting out during operation because the chainsaw is too hot. If so, remove the battery and allow the chainsaw to cool down. Alternatively, there may be an electrical malfunction. To address this, remove the battery and insert it again, then switch the saw back on.
  • E
    Emily PowellAug 28, 2025
    What to do if my Stihl Chainsaw does not start when switched on?
    • G
      grace10Aug 28, 2025
      If your Stihl Chainsaw doesn't start, the cause could be a low battery charge, or the battery is too hot or cold. Recharge the battery fully as described in the instruction manual for the STIHL chargers or allow the battery to cool down/warm up. Other possible causes include a malfunction in the saw or battery, no electrical contact between the chainsaw and battery, or the saw or battery being damp. For malfunctions, engage the chain brake, remove the battery, clean the contacts, refit the battery, disengage the chain brake, and switch on the saw. If the problem persists (3 or 4 LEDs flash red), contact your STIHL servicing dealer for assistance. For electrical contact issues, engage the chain brake, remove and refit the battery. If the saw or battery is damp, allow them to dry.
  • A
    Andrew FloresSep 23, 2025
    How to improve Stihl Chainsaw runtime that is too short?
    • V
      Virginia TaylorSep 23, 2025
      If your Stihl Chainsaw's runtime is too short, it could be because the battery is not fully charged, or the normal battery life has been exceeded. Recharge the battery fully as described in the instruction manual for the STIHL chargers or replace the battery.
  • A
    Amy GordonNov 25, 2025
    What to do if my Stihl Saw does not start when switched on?
    • M
      murillochelseaNov 25, 2025
      If your Stihl Saw doesn't start, there could be several reasons. The battery might have a low charge – recharge it fully. It could be too hot or too cold; if so, engage the chain brake, remove the battery, and allow it to cool down or warm up. There might be a malfunction in the saw; in that case, engage the chain brake, remove the battery, clean the contacts, refit the battery, disengage the brake, and switch the saw on. If 3 LEDs flash red, contact your STIHL dealer. The chainsaw itself might be too hot, so remove the battery and let it cool. There could be a battery malfunction; engage the chain brake, remove and refit the battery, disengage the brake, and switch the saw on. If 4 LEDs flash red, contact your STIHL dealer. Also, check for no electrical contact – remove and refit the batt...
  • S
    snowmarkSep 12, 2025
    What to do if 4 LEDs flash red on my Stihl MSA 161 T Chainsaw?
    • J
      Jordan LynchSep 12, 2025
      If 4 LEDs flash red on your Stihl chainsaw (accompanied by rapid short beeps on STIHL AR models), it indicates a battery malfunction. Try removing and reinserting the battery. If the LEDs continue to flash, do not use the battery and replace it.
  • H
    Holly BaileySep 12, 2025
    What does it mean when 3 LEDs are flashing red on a Stihl MSA 161 T?
    • L
      Larry LopezSep 13, 2025
      If 3 LEDs flash red on your Stihl chainsaw, it indicates a malfunction. Remove and reinsert the battery. If the LEDs continue to flash, do not attempt to use the chainsaw and have it checked by a servicing dealer.
  • L
    Loretta CantrellSep 5, 2025
    What to do if my Stihl MSA 161 T is too hot?
    • D
      Donna AcostaSep 5, 2025
      If your Stihl chainsaw is too hot, engage the chain brake and remove the battery. Allow the chainsaw to cool down.
  • J
    Jennifer ContrerasSep 3, 2025
    What to do if there is a smoke or burning smell while cutting with Stihl Saw?
    • M
      Maria RodriguezSep 3, 2025
      If you notice smoke or a burning smell while cutting with your Stihl Saw, several factors could be responsible. First, the chain may not be properly sharpened, so sharpen the chain. Second, there might be insufficient chain oil in the tank, so fill it up. Third, the chain lubrication system may be supplying insufficient chain oil, in which case you should not use your chainsaw and contact your STIHL servicing dealer for assistance. The chain could also be over-tensioned, so tension the chain properly. Finally, the chainsaw may not be used properly, so have the correct use explained, then practice.

Summary

Main Parts of the Chain Saw

Chain Saw and Battery Components

Identifies and describes the main parts of the STIHL MSA 161 T chain saw and its battery.

Safety Symbols on the Products

Chain Saw Safety Symbols

Details safety symbols found on the chain saw and their meanings.

Battery Safety Symbols

Details safety symbols found on the battery and their meanings.

Important Safety Instructions

Intended Use of the Chain Saw

Specifies the intended use of the STIHL MSA 161 T chain saw and its limitations.

Operator Requirements and Health

Outlines physical and mental health requirements for operating the chain saw.

Personal Protective Equipment (PPE)

Details essential protective clothing and gear for safe chain saw operation.

Kickback and Other Reactive Forces

Understanding Reactive Forces

Explains dangerous forces that can occur during chain saw operation.

Kickback Hazards and Prevention

Details the causes, risks, and prevention methods for kickback.

How to Avoid Kickback

Provides practical steps and techniques to prevent kickback situations.

Basic Working Technique

Battery Safety

Battery Warnings and Instructions

Covers essential safety precautions and instructions for battery handling.

Maintenance, Repair, and Storage

Maintenance Warnings and Instructions

Emphasizes safety during maintenance and repair operations.

Charging the Battery

Charging the Battery

Details the procedure and indicators for charging the battery.

Assembling the Chain Saw

Cutting Attachment Assembly

Covers the assembly of the chain, guide bar, and chain sprocket.

Mounting and Removing Guide Bar and Chain

Step-by-step guide for attaching and detaching the guide bar and chain.

Tensioning the Chain

Explains how to properly tension the saw chain for safe operation.

Lubricating Saw Chain and Guide Bar

Details the importance of lubrication and recommended oils.

The Chain Brake

Engaging the Chain Brake

Instructions on how to activate the chain brake.

Disengaging the Chain Brake

Instructions on how to deactivate the chain brake.

Maintaining the Chain Brake

Guidelines for periodic inspection and servicing of the chain brake.

Inserting and Removing the Battery

Switching the Chain Saw On and Off

Switching the Chain Saw On

Details the procedure for safely starting the chain saw.

Switching the Chain Saw Off

Details the procedure for safely stopping the chain saw.

Checking the Chain Saw

Storing the Chain Saw and Battery

Cleaning the Chain Saw and Battery

Inspection and Maintenance

Inspecting, Maintaining, and Sharpening the Saw Chain

Comprehensive guide to checking, maintaining, and sharpening the saw chain.

Troubleshooting Guide

Stihl MSA 161 T Specifications

General IconGeneral
Idle speed- RPM
Chain pitch1/4 \
Blade length250 mm
Product colorBlack, Grey, Orange
Quick stop functionYes
Power sourceBattery
Battery voltage36 V
Sound power level94 dB
Vibration emission2.2 m/s²
Sound pressure level83 dB
Weight and Dimensions IconWeight and Dimensions
Weight2500 g

Related product manuals