Stihl 029, 039 - Page 20

STIHL 029, 039 20
Top: Top:
Fitting the link Top: Assembly tube 1117 890 0900
Fitting the brake band
Bottom: Bottom:
Attaching brake band to bell Bottom: Attaching brake spring to
crank Attaching the brake spring anchor pin
- Fit the washer on the bell crank Important: Coat sliding and - Slip the bush over the hand
pivot pin. bearing points with Molykote guard mounting screw. Fit screw
grease - see 12.2. Do not and tighten to 3.5 Nm (2.6 Ibf.ft).
- Position the link on the hand lubricate the brake band.
guard pivot pin and slide it down - Fit cover for brake band.
until it engages the groove on the - Attach the brake spring to the
end of the pivot pin. Then push bell crank. - Fit bumper strip in its seat.
link over the bell crank pivot pin
and secure it with the E-clip. - Use the assembly tool and a - Install the clutch drum or chain
screwdriver to attach the brake sprocket - see 3.1.
- First attach brake band to bell spring to the anchor pin.
crank and then push it into the
engine housing recess.