Stihl 029, 039 - Page 74

STIHL 029, 039 74
Top:
Levers "A" and "B" joined
by link "C"
Bottom:
D = Torsion spring
E = Throttle shaft
Top:
Fitting levers "A" and "B"
Bottom:
Rotating lever "B"
Top:
Fitting bell crank "G"
Bottom:
Pressing home bell crank "G"
- Fit the bell crank "G" (with flat face
pointing to lever "B") over the choke
shaft so that the pin on lever "B" is
between the arms of bell crank "G".
- Rotate bell crank counterclock-
wise until its right arm butts
against the pin on lever "B".
- With the bell crank in this posi-
tion, carefully press it on to the
choke shaft.
Important: Take care not to bend the
shaft.
- Push lever "A" on to the throttle
shaft and, at the same time, lever
"B" on to the choke shaft.
- Rotate lever "B" on choke shaft
counterclockwise as far as stop.
- Carefully push the link "C" into
position to connect levers "A"
and "B".
- Fit the torsion spring on the throttle
shaft so that its bent end points
away from the carburetor.