Stihl 088

STIHL 088 42
• Fit the handle molding and make
sure it engages properly.
- Fit the filter base - see 10.1.
8.2 Throttle Tri
gg
er/Interlock Leve
r
- Remove the filter base - see 10.1.
• Take out the screw.
- Remove the handle molding.
• Use a 5 mm (3/16") drift to drive
out the dowel pin (1).
• Take out the throttle trigger (2)
with torsion spring (3).
• Remove the torsion spring from
the throttle trigger.
- The torsion spring must be fitted
under the interlock lever and
locate in the notch.
- Move Master Control lever to
"Run" position.
• Take out the interlock lever.
• Press the interlock lever (1) down.
• Pull the throttle trigger (2) up and
move the Master Control lever (3)
to "Choke".
• Pull the throttle rod out of the
throttle trigger.