Stihl 088 - Carburetor Service and Leakage Test

STIHL 088 48
10.2 Carbureto
r
10.2.1 Removing and Installing
- Remove the filter base - see 10.1.
• Pull the grommet off the adjusting
screws and out of the housing.
• After pushing carburetor into
position, check that elbow con-
nectors are properly seated in
impulse hose (1) and fuel hose
(2).
- Remove the handle molding
- see 8.2.
• Disconnect the throttle rod from
the double lever.
• Lift away the carburetor.
Reassemble in the reverse
sequence.
• Disconnect choke rod from the
choke lever.
• Before installing the carburetor,
check that sleeve is in position.
• Disconnect the impulse hose (1)
and fuel hose (2).
• Pull off the sleeve (3).