65Series 4144 Components FC, FS, KM
9. Drive Tube
9.1 Removing and Installing
The drive tube can be removed from
the machine without dismantling
other parts.
Machines with loop handle
: Take out the screw (1) and
loosen the screws (arrows).
– Pull out the drive tube (2).
– Check the drive tube and repair
or replace if necessary, b 9.1
Machines with bike handle
: Loosen the screw (arrow).
– Pull off the control handle (1).
2
1
545RA001 TG
1
545RA073 TG
: Take out the screw (1) and
loosen the screws (arrows).
– Pull the drive tube (2) out of the
engine housing.
– Check the drive tube and repair
or replace if necessary, b 9.1
If a new drive tube is installed, the
other parts and components must
be transferred from the old drive
tube.
Installing
– Degrease the clamp area with a
little standard solvent-based
degreasant containing no
chlorinated or halogenated
hydrocarbons,
b 11
Machines with loop handle
: Position the drive tube (1) so that
the holes are in alignment.
2
1
545RA000 TG
1
545RA002 TG
– Push home the drive tube (1) as
far as stop, turn the drive shaft to
and fro until the square end of the
drive shaft engages the square
recess in the clutch drum.
: Turn the drive tube (1) until the
holes (arrow) in the drive tube
and engine housing line up.
– Insert and tighten down the screw
– turn the drive tube to and fro
until the screw slips through the
hole – the drive tube is only
located and not clamped in
position at this stage.
: Tighten down the screws
(arrows) firmly.
1
545RA003 TG545RA004 TG
To Next Page
Loading...
