67Series 4144 Components FC, FS, KM
– Slip the washer (1) on to the
driver (2).
– Line up the bushing (3) with its
collar (arrow) facing the driver.
– Coat needle bearing in bushing
and shank of driver with STIHL
lubricating grease, b 11
: Push the bushing (3) into
position.
– Fit the washer (2).
: Fit the E-clip (1).
2
545RA239 TG
13
1
545RA241 TG
2
: Push the wire clips into the driver
so that their long sides (arrows)
are offset.
– Push the wire clips home as far
as stop – they must be firmly
seated.
: Push the complete driver (1) into
the drive tube so that the lug (2)
engages the notch (arrow).
– Push the driver home as far as
stop.
: Push the flexible liner (1) into the
end of the drive tube with the
cross holes (arrows).
545RA240 TG
2
1
545RA242 TG545RA243 TG
1
: Line up the flexible liner (1) so
that the cross holes (arrows) in
the drive tube are between the
spokes.
: Push the plug (1) into the drive
tube as far as stop.
545RA245 TG
1
1
545RA021 TG
To Next Page
Loading...
