BR 800, BR 800 X
English
23
N With the blower on your back, make
sure that bystanders are well clear
of the nozzle outlet.
N Make sure you have good balance
and secure footing.
N Hold blower tube with your right
hand on the control handle.
N Pull the starter rope steadily with
your left hand, allow it to rewind and
continue pulling until the engine
starts.
N Do not pull out the starter rope all
the way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
If engine does not start
Choke knob
If you did not turn the choke knob to o
quickly enough after the engine began to
start, the combustion chamber is
flooded.
N Push the setting lever (1) upwards.
The throttle trigger (2) is in the full
throttle position.
N Continue pulling the starter rope
until the engine runs.
Other Hints on Starting
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
N Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
Engine stalls in cold start position c or
under acceleration
N Move the choke knob to o and
continue pulling the starter rope
until the engine runs.
Engine does not start in warm start
position o
N Move the choke knob to c and
continue pulling the starter rope
until the engine runs.
Fuel tank run until completely dry
N After refueling, depress the manual
fuel pump bulb at least 6 times –
even if the bulb is already filled with
fuel.
N Set the choke knob according to
engine temperature.
N Now start the engine.
To Next Page
Loading...
Need help?
General
