Stihl FC 95 User Manual

FC 95, FC 110
English
14
N Tighten down the wingnut
clockwise.
N Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
WARNING
Do not adjust the deflector.
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
operator. This ensures that cuttings and
other debris are directed away from the
power tool and operator.
Edging
N Start the engine.
N Start the cut at no less than half
throttle and continue cutting at full
throttle.
N Hold and guide your power tool so
that the blade is vertical.
N Cut steadily so that the engine is not
lugged down – do not apply force.
N Operate at no more than a normal
walking pace.
N Do not push the blade into the
ground.
N Always walk forwards when cutting,
do not pull the unit towards you.
N Cut at a steady pace to avoid having
to make several passes.
N Use the gunning sight (1) to line the
blade up with the edge of the bed.
257BA006 KN
257BA007 KN
257BA008 KN
1
257BA009 KN

Stihl FC 95 Specifications

General

Brand	Stihl
Model	FC 95
Category	Trimmer
Language	English