Stihl FC 95

FC 95, FC 110
English
16
N Slide the handle to the required
position.
N Tighten down the screw with the
combination wrench so that the
handle cannot be rotated on the
drive tube.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
N Adjust the throttle cable only when
the unit is completely and properly
assembled.
N Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
N Lay the power edger on its back so
that the blade mounting (1) faces
up.
N Insert the stop pin (2) into the
hole (3) as far as stop – apply slight
pressure and turn back and forth
Adjusting the Throttle Cable
002BA163 KN
2
1
002BA161 KN
Mounting the Cutting Blade
257BA013 KN
4
3
6
2
257BA014 KN
5