Stihl FC 95 User Manual

FC 95, FC 110
English
23
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
The carburetor comes from the factory
with a standard setting.
On this machine it is no longer
necessary to adjust the carburetor.
It has been set at the factory to provide
an optimum fuel-air mixture in all
locations and operating conditions.
Adjusting Idle Speed
Engine stops while idling
N Warm up the engine for about
3 minutes.
N Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly – the cutting blade
must not rotate.
Blade rotates when engine is idling
N Turn the idle speed screw (LA)
counterclockwise until the blade
stops rotating and then turn the
screw about another 1/2 to 3/4 turn
in the same direction.
WARNING
If the cutting blade continues to rotate
when the engine is idling, have your
machine checked and repaired by your
servicing dealer.
Engine Management Adjusting the Carburetor
249BA066 KN
LA
H L

Stihl FC 95 Specifications

General

Brand	Stihl
Model	FC 95
Category	Trimmer
Language	English