Stihl FS 111 RX - Mounting the Loop Handle; Adjusting the Throttle Cable

FS 111 RX
English
16
Polymer Version
For position of carrying ring see "Main
Parts".
N Push the carrying ring (1) over the
drive tube.
N Insert the M5 nut in the hex recess
in the carrying ring.
N Fit the M5x14 screw.
N Line up the carrying ring.
N Tighten down the screw firmly.
Laying down the machine
N Switch off the engine
N Lay down the machine so that the
mount for the cutting attachment
faces upward
Blocking the shaft
To mount and remove the cutting
attachments, the shaft (1) must be
blocked with the locking pin (2) or Allen
wrench (2). The parts are included in the
scope of delivery and are available as
special accessories.
N Push the locking pin (2) or Allen
wrench (2) as far as it will go into the
hole (3) in the gear – press gently
N Turn the shaft, nut or cutting
attachment until the locking pin
engages and the shaft is blocked
Mounting the STIHL PolyCut 20-3
Keep the supplement sheet for the
mowing head in a safe place.
WARNING
Only mount the mowing head with
doubled stepped support as shown
above.
Mounting the mowing head with a
threaded connection
Keep the supplement sheet for the
mowing head in a safe place.
Fitting the Carrying Ring
1
002BA529 KN
Mounting the Cutting
Attachment
002BA342 KN
2
3
1
002BA569 KN
2
259BA012 KN