Stihl FS 111 RX - Page 22

FS 111 RX
English
20
Balancing the Machine
N Adjust the carrying ring.
N Tighten the screw moderately.
N Let go of the brushcutter and check
to see how it is balance – the cutting
attachment should just touch the
ground in the normal working
position.
N Move the carrying ring as required.
When the correct balanced position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Disconnecting Machine from Harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Depress the stop switch
(…) to switch off the ignition – see
"Function of stop switch and ignition
system".
Function of stop switch and ignition
system
The ignition is switched off and the
engine stopped when the stop switch is
pressed. The stop switch returns
automatically to the Run position when it
is released: The ignition is switched on
again after the engine stops – the engine
is then ready to start.
Starting the Engine
N Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is already filled with fuel.
N Press in the choke knob (8) and turn
it to the position that suits the engine
temperature:
The choke knob must engage in
position.
0000-GXX-1289-A0
1
1
0000-GXX-1290-A0
2
2
Starting / Stopping the
Engine
2
1
3
0000-GXX-0477-A0
g if the engine is cold
< for warm start – also use this posi-
tion if the engine has been running
but is still cold.
0000-GXX-0478-A0