Stihl FS 250 R User Manual

FS 250, FS 250 R
English
26
Control handle on drive tube
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4STOP-0 – engine off – ignition is
switched off
5 F – normal run position – the engine
is running or can start
6START – ignition is switched on –
the engine can start
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
N Press down the trigger lockout lever
and squeeze the throttle trigger
N and hold them in that position.
N Move the slide control to START
and hold it there.
N Now release the throttle trigger,
slide control and trigger lockout
lever in that order. This is the
starting throttle position.
N Set the choke knob (8) to:
N Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
N Place the unit on the ground: It must
rest securely on the engine support
and the deflector.
N If fitted: Remove the transport guard
from the cutting attachment.
To reduce the risk of accidents, check
that the cutting attachment is not
touching the ground of any other
obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or slide control.
NOTICE
Do not stand or kneel on the drive tube.
3
STOP
2
5
6
4
7
002BA181 KN
START
STOP-
1
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
250BA018 KN
9
8
002BA038 KN
002BA040 KN

Stihl FS 250 R Specifications

General

Brand	Stihl
Model	FS 250 R
Category	Trimmer
Language	English