FS 300, FS 350, FS 380
English
69
N Open the tank cap.
N Fill up with fuel.
N Closing the Tank Cap
WARNING
After fueling, tighten down the filler cap
as securely as possible by hand.
To use the harness – see chapter
"Approved Combinations of Cutting
Attachment, Deflector, Handle and
Harness".
Shoulder strap
We recommend using a full harness for
this machine, because of its weight and
for ergonomic reasons.
Full harness
The full harness is supplied together
with an information sheet showing how
to fit it.
Fitting the harness
N Put on the harness (1)
N Adjust the strap length so that the
snap hook (2) is approximately a
hand's breadth below the right hip.
N Attach the snap hook (2) to the
perforated strip (3) on the machine
– refer to next chapter ‘Connecting
machine to harness’.
N Balance the machine – refer to
chapter ‘Balancing the machine’.
Trim excess strap lengths at the ends
after adjusting.
Fitting the Harness
To Next Page
Loading...
