Stihl FS 410 C K User Manual

FS 410 C K
English
25
Installing the Spark Plug
N Screw the spark plug into the
cylinder.
N Press the spark plug boot firmly
onto the spark plug.
N Fit the cap (1) on the shroud from
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
N Swing the cap forwards onto the
shroud, insert and tighten down the
screw (4) firmly.
If engine running behavior is still
unsatisfactory after the air filter has been
serviced and the carburetor and throttle
cable have been adjusted correctly, the
cause may also be in the muffler.
Have the muffler checked for
contamination (coking) by a servicing
dealer!
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.
Removing the Rewind Starter
N Take out the screws (1).
N Lift away the rewind starter.
Replacing the Starter Rope and Rewind
Spring
N If either the starter rope or rewind
spring is broken, continue with
"Removing the Rope Rotor".
N If either the starter rope or rewind
spring are being replaced as a
precautionary measure, continue
with the following chapter.
4
3
2
9926BA022 KN
Engine Running Behavior Replacing the Starter Rope
and Rewind Spring
1 1
1 1
9926BA023 KN

Stihl FS 410 C K Specifications

General

Brand	Stihl
Model	FS 410 C K
Category	Trimmer
Language	English