Stihl FS 56 C-E - Starting and Stopping the Engine; Controls Overview; Stop Switch and Ignition System Function

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
29
When the correct floating position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Detaching the unit from the harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Controls
Version with bike handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Version with loop handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 =Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. If the stop switch is moved to the
0 position, the ignition is switched off. It
is automatically switched on again after
the engine comes to a standstill.
1
2
1
2
002BA312 KN
Starting / Stopping the
Engine
1
002BA268 KN
2
3
002BA269 KN
1
3
2