Stihl FS 85 - Fitting the Harness; Balancing the Brushcutter

33FS 80, FS 80 R, FS 85, FS 85 R
English / USA
The type and style of harness depend on
the market.
Shoulder Strap
: Put on the shoulder strap (1).
: Adjust the length of the strap so that
the spring hook (2) is about a hand’s
width below your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
Full harness
: Put on the full harness (1).
: Adjust length until the spring hook
(2) is about a hand’s width below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
Attaching Harness to Brushcutter
: Attach the spring hook (1) to the
clamp (2) (carrying ring) on the drive
tube.
Fitting the Harness Balancing the Brushcutter