37FS 90, FS 90 R
English / USA
Symbol on slide control
h (7) – stop symbol and arrow – to stop
the engine, push the slide control in
direction of arrow on stop symbol (h ) to
STOP-O.
Starting
: Hold down the throttle trigger
interlock and squeeze the throttle
trigger.
: While holding both levers in this
position
: move the slide control to START
and hold it there.
: Now release the throttle trigger,
slide control and trigger interlock in
that order. This is the starting
throttle position.
: Set the choke knob (8):
For cold start to
g
For warm start to e
even if engine has been running but
is still cold
: Press fuel pump bulb (9) at least five
times – even if the bulb is already
filled with fuel.
: Place the unit on the ground: It must
rest securely on the engine support
and deflector.
Check that the cutting tool is not
touching the ground or any other
obstacles.
: Make sure you have a firm footing.
: Hold the unit with your left hand and
press it down firmly – your thumb
should be under the fan housing.
Do not stand or kneel on the drive
tube!
249BA007 KN
9
8
To Next Page
Loading...
