Stihl FSA 130 - Fitting and Removing the Skirt; Mounting and Removing the Mowing Head

0458-726-9921-A
48
English 6 Assembling the Trimmer
6.3 Fitting and Removing the Skirt
6.3.1 Fitting the Skirt
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Slide the guide slot in the skirt (2) onto the deflector (1) –
it must snap into position.
► Push the line limiting blade (3) into the slot in the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.3.2 Removing the Skirt
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the deflector.
The line limiting blade (1) can be left on the skirt.
6.4 Mounting and Removing the Mowing Head
6.4.1 Mounting the Mowing Head
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Place the thrust plate (2) on the shaft (3) so that its smaller
diameter faces up.
► Fit the mowing head (1) on the shaft (3) and turn it
counterclockwise.
► Insert the stop pin (4) in the bore as far as stop and hold
it depressed.
► Rotate the mowing head (1) counterclockwise until the
stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by hand.
► Remove the stop pin (4).
6.4.2 Removing the Mowing Head
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the mowing head (3) until the stop pin engages in
position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
3
2
4
0000-GXX-3028-A1
1
1
0000-GXX-3030-A2
2
2
3
4
0000-GXX-3031-A0
1
4
1