Stihl FSE 41 - Adjusting the Handles; Adjusting Length of Shaft (FSE 41 only)

FSE 31, FSE 41
English
11
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the nylon lines are shorter than 2.5cm,
readjust them manually – see "Manual
Adjustment of Nylin Line".
Manual Adjustment of Nylon Line
N Switch off the trimmer.
N Disconnect the plug from the wall
outlet.
N Turn the trimmer on its back.
N Push home the button (1) on the
spool as far as stop.
N Pull the ends of the nylon line (2) out
of the spool.
If the spool is empty, see "Replacing
Nylon Line".
Adjusting Length of Shaft (FSE 41 only)
N Press in the lock button (1).
N Pull the control handle (2) upwards
on the shaft (3) and engage it in one
of the 3 positions: A, B or C
Adjusting Nylon Line
1
280BA007 KN
2
280BA019 KN
1
2
2
Adjusting the Handles
2
1
280BA008 KN
3
A
B
C