15FSE 60, FSE 71, FSE 81
English
: Make sure you have a secure and
balanced footing.
: Hold the unit with both hands – right
hand on the control handle – left
hand on the loop handle.
: Stand upright – hold the unit in a
relaxed position and always on the
right-hand side of your body.
: Make sure the cutting tool is not
touching the ground or any other
object.
: Press down the starting lockout
lever (1) and hold it in that poistion.
: Squeeze the trigger switch (2).
: Release the trigger switch and the
starting lockout lever.
Note that cutting tool continues to
rotate for a brief period after you
release the trigger switch and
starting lockout lever – flywheel
effect!
During long work breaks – disconnect
the plug from the power supply.
When the power tool is not in use, store
it in such a way that it does not endanger
others.
Secure your power tool against
unauthorized use.
For periods of about 3 months or longer:
: Thoroughly clean the machine,
especially the cooling air inlets.
: Take out the spool with nylon lines
and attach the ends of the lines in
the spool’s notches.
Clean and inspect the spool.
The resilience and service life of the
nylon line can be increased by
storing it in water.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
Switching On
2
1
238BA010 KN
Switching Off Storing the Machine
To Next Page
Loading...
