3FSE 60, FSE 71, FSE 81
English
Special safety 
precautions must be 
observed when working 
with this electric power 
tool because of its high-
speed cutting attachment.
It is important that you 
read and understand the 
instruction manual before 
using your power tool for 
the first time. Keep it in a 
safe place for later 
reference. Non-observance of the 
following safety precautions may cause 
serious or even fatal injury.
Always observe local safety regulations, 
standards and ordinances.
If you have never used this power tool 
model before: Have your servicing 
dealer or a trained expert show you how 
to operate your power tool or attend a 
special course of training in power tool 
operation.
Minors should never be allowed to use 
this power tool.
Children, bystanders and animals 
should not be allowed in the area where 
a power tool is in use.
When the machine is not in use, shut it 
off so that it does not endanger others 
and secure it against unauthorized use.
The operator is responsible for avoiding 
injury to third parties and damage to 
their property.
Do not lend or rent your power tool 
without the instruction manual. Be sure 
that anyone using your power tool 
understands the information contained 
in this manual.
You must be rested, healthy and in good 
physical condition to operate a power 
tool.
If you have any condition that may be 
aggravated by strenuous work, check 
with your doctor before operating the 
power tool.
Do not operate this power tool while 
under the influence of any substance 
(drugs, alcohol) which might impair 
vision, dexterity or judgment.
Depending on the cutting tool fitted, use 
your power tool only for cutting grass, 
wild growth and similar materials. 
Do not use your power tool for any other 
purpose since this may result in 
accidents or damage to the machine. 
Never attempt to modify your power tool 
in any way since this may also result in 
accidents or damage to the machine.
To reduce the risk of accidents, always 
disconnect the plug from the power 
supply before carrying out any work on 
the power tool.
Never jerk the power cord to disconnect 
the plug from the wall outlet. To unplug, 
grasp the plug, not the cord.
Unsuitable extension cords can be 
extremely dangerous.
Make sure that the conductor cross 
section (wire gauge) of the extension 
cord meets the minimum requirements 
(see "Connecting to Power Supply”).
Safety Precautions and 
Working Techniques