Stihl FT 250 - Mounting the Bike Handle; Mounting the Handlebar

FT 250
English
11
Mounting the Handlebar
N Place the rubber liner (1) in the
clamp (2) and against the drive
tube (3).
N Position rubber liner (4) on the drive
tube so that it lines up exactly with
the lower rubber liner.
N Place the handle support (5) on the
rubber liner.
N Fit the handlebar (6) in the handle
support – the rubber handle (7)
must be on the left (viewed from the
engine).
N Place the clamp (8) on the handle
support and handlebar.
N Insert the screws (9) through the
holes in the parts and screw them
into the lower clamp (2) – do not
finally tighten yet.
Lining up the handlebar
N Secure the handlebar (1) on the
drive tube (2) about 43 cm (17 in.)
(A) from the engine.
N Line up the handlebar and tighten
down the screws firmly.
Mounting the Bike Handle
3
262BA032 KN
1
2
4
5
9
2
7
8
6
262BA033 KN
262BA051 KN
A
2
1