FT 250
English
31
Maintenance and Care
The following intervals apply to normal operating conditions only. If your daily work-
ing time is longer or operating conditions are difficult (very dusty work area, etc.),
shorten the specified intervals accordingly.
before starting work
after finishing work or daily
after each refueling stop
weekly
monthly
every 12 months
if problem
if damaged
as required
Complete machine
Visual inspection (condition, leaks) XX
Clean X
Replace any damaged parts XX
Control handle Check operation XX
Air filter, synthetic fabric filter
Visual Inspection XX
Clean X
Replace XX
Air filter, paper filter
Visual inspection XX
Replace
1)
X
Manual fuel pump (if fitted)
Check X
Have repaired by servicing dealer
2)
X
Pickup body in fuel tank
Check X
Replace XXX
Fuel tank Clean XXX
Carburetor
Check idle adjustment – the cutting
attachment must not rotate
XX
Adjust idle speed X
Spark plug
Adjust electrode gap X
Replace after every 100 operating hours
Cooling inlets
Visual inspection X
Clean X
Exhaust port
Have cleaned by servicing dealer
2)
after
first 139 hours of operation, then every
150 hours of operation
X
All accessible screws and nuts (not adjust-
ing screws)
Retighten X
To Next Page
Loading...
