FT 250
English
20
N Press down the bar on one
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
N Slip the strap off your left shoulder.
N Let the machine and shoulder strap
fall to the ground.
Both methods:
Practice removing and putting down the
machine as you would in an emergency.
To avoid damage, do not throw the
power tool to the ground when
practicing.
Controls
Control handle on handlebar
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4STOP-0 – engine off – the ignition is
switched off.
5 F – normal run position – the engine
is running or can start
6START – ignition is switched on –
the engine can start
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
N Press down the trigger lockout lever
and squeeze the throttle trigger
N and hold them in that position.
N Move the slide control to START
and hold it there.
N Now release the throttle trigger,
slide control and trigger lockout in
that order. This is the starting
throttle position.
N Set the choke knob (8) to:
N Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
N If fitted: Remove the transport guard
from the cutting attachment.
To Next Page
Loading...
