FT 250
English
13
N Place the padding (1) against the
underside of the drive tube and fold
it up and around the drive tube.
N Close the padding with the press
studs (2).
N Rotate the padding until the press
studs are under the drive tube.
Mounting the Limit Stop
WARNING
The limit stop (1) must be mounted on
the gearhead when you use a circular
saw blade.
N Position the limit stop (1) on the
gearhead flange.
N Fit the three M6 x 14 mm screws (2)
provided and tighten them down
firmly.
Placing power tool on the ground
N Shut off the engine.
N Lay your power tool on its back so
that the cutting attachment
mounting face is pointing up.
Blocking the Shaft
The drive shaft must be blocked with the
stop pin to mount and remove the cutting
attachment. The stop pin is included with
the machine and is available as a
special accessory.
Fitting Padding
To Next Page
Loading...
