EasyManua.ls Logo

Stihl HSA 50 - Switching the Hedge Trimmer On;Off; Switch on the hedge trimmer; Switching off the hedge trimmer

Stihl HSA 50
304 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Depress the locking lever and hold it in that
position.
Press and hold the trigger.
If the cutting blades run: Do not use your
hedge trimmer; contact your STIHL authorized
dealer.
The control bar is defective.
Depress the control bar and hold it in that
position.
The cutting blades run.
If 3 LEDs flash red: Remove the battery and
consult a STIHL dealer.
There is a malfunction in the hedge trimmer.
Release the control bar.
The cutting blades stop running after about 1
second.
If the cutting blades continue to run after 1
second: Remove the battery and contact your
STIHL authorized dealer.
The hedge trimmer is defective.
9.2 Testing the Battery
Press button on battery.
The LEDs glow or flash.
If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
10 Operating the Hedge Trim‐
mer
10.1 Holding and Controlling the
Hedge Trimmer
0000-GXX-1455-A0
Hold the hedge trimmer with one hand on the
control handle – wrap your thumb around the
control handle.
Hold the hedge trimmer with the other hand on
the loop handle – wrap your thumb around the
loop handle.
10.2 Cutting
Use lopping shears or a chainsaw to cut out
thick branches first.
0-10°
0000-GXX-1456-A0
Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
Lower the nose of the hedge trimmer without
cutting.
Walk slowly and steadily forwards.
Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
Cut the other side of the hedge in the same
way.
Hold the cutting blades at an angle of 0° to 10°
to the top of the hedge.
Swing the hedge trimmer horizontally and in
an arc while making the cut.
If cutting performance deteriorates: Sharpen
the cutting blades.
11 After Finishing Work
11.1 After Finishing Work
Switch off the hedge trimmer and remove the
battery.
If the hedge trimmer is wet: Allow the hedge
trimmer to dry.
If the battery is wet: Allow the battery to dry.
Clean the hedge trimmer.
Clean the cutting blades.
Fit the blade scabbard so that it completely
covers the cutting blades.
Clean the battery.
12 Transporting
12.1 Transporting the Hedge Trim‐
mer
Switch off the hedge trimmer and remove the
battery.
Fit the blade scabbard so that it completely
covers the cutting blades.
Carrying the hedge trimmer
Carry the hedge trimmer by the loop handle
with the cutting blades behind you.
Transporting the Hedge Trimmer in a vehicle
Secure the hedge trimmer to prevent it tipping
over and moving.
10 Operating the Hedge Trimmer English
0458-018-9801-A 35

Table of Contents

Related product manuals