Stihl HTA 135 - Reactive Forces and Kickback; Reactive Forces and Kickback Avoidance

0458-698-0121-A
17
English 7 Assembling the Pole Pruner
► Remove the protective cap (11).
► Turn the shaft (2) and press it in the direction of the control
handle (12) until the distance c = 2 cm.
► Align the housing (13) and transmission (3) as shown.
► Tighten down the screws (9) firmly.
The pole pruner does not need to dismantled again.
7.2 Attaching the clip
► Switch off the pole pruner and remove the battery.
► Press clip (1) together and place on the handle hose (2).
It is not necessary to remove the clip again.
7.3 Mounting the machine support
► Switch off the pole pruner and remove the battery.
► Position the left half of the machine support (1) against the
side of the cover.
► Fit the screw (2).
► Position the right half of the machine support (3) against
the side of the cover.
► Fit the screw (5).
► Insert screws (4) and tighten.
► Tighten screw (2) and screw (5) firmly.
It is not necessary to remove the machine support again.
11
12
2
0000097973_001
c
13
c
3
90°
90°
0000098532_001
1
2
0000097169_001
5
2
1
4
3
0000097173_001