Stihl KW 85 - Fitting Carrying Eye* (Clamp); Mounting the Loop Handle

10
english / USA
KW 85
: For position of carrying eye (clamp)*
see “Parts and Controls”
: Place the clamp (1) with tapped
hole against the left-hand side of the
drive tube.
: Place the other half of the clamp (2)
against the right-hand side of the
drive tube.
: Slide the two clamps together so
that their slots engage.
: Insert M 6 x 14 screw (3).
: Line up the carrying eye.
: Tighten down the screw.
* see “Guide to Using this Manual”
: Place liner in loop handle as shown. : Fit the loop handle (1) on the drive
tube approx. 8 in (20cm) (A) forward
of the control handle (2).
: Slide spacer (3) into loop handle as
far as stop.
: Insert screw (4) in loop handle and
through spacer until the hexagon
head engages the socket in the
loop handle.
: Fit washer (5) and wingnut (6) and
tighten down firmly.
Fitting Carrying Eye*
(Clamp)
002BA115 KN
1
2
3
1
2
3
Mounting the Loop Handle
223BA017 KN
223BA018 KN
4
6
5
232BA027 KN
1
2
3
A