27KW 85
english / USA
: Take out the screw (5).
: Remove the rope rotor very
carefully –
the rewind spring is seated in the
rope rotor and may pop out and
uncoil if care is not taken.
: Use a screwdriver to ease the cap
(6) out of the starter grip.
: Remove remaining rope from the
rotor and grip, making sure the
ElastoStart sleeve is not pushed out
of the grip.
: Tie a simple overhand knot in the
end of the new starter rope and then
thread the rope through the top of
the grip and the rope bush (7).
: Refit the cap in the grip.
: Pull the rope through the rotor and
secure it with a simple overhand
knot.
: Coat rope rotor bearing bore with
non-resinous oil**.
: Slide rotor onto starter post –
turn it back and forth until the rewind
spring anchor loop (8) engages.
: Insert screw and tighten down
securely.
Go to "Tensioning the rewind
spring".
** see “Special Accessories“
5
392BA014 KN
6
7
392BA015 KN
392BA024 KN
8
392BA025 KN
To Next Page
Loading...
