30
English / USA
MS 192 T
: Push hand guard (1) forward:
The chain is now locked.
: Press down the trigger interlock (2)
and squeeze the throttle trigger (3)
at the same time – hold both levers
in that position.
: Move Master Control (4) to n and
hold it there.
: Now release the throttle trigger,
Master Control and trigger interlock
in that order. This is the starting
throttle position.
If engine is cold
: Set the choke lever (5) to l
If engine is warm
: Set the choke lever (5) to j.
Also use this position if the engine
has been running but is still cold.
: Place your saw on the ground.
: Make sure you have a firm footing –
check that chain is not touching any
object or the ground.
Bystanders must be well clear of the
general work area of the saw.
: Hold the saw firmly on the ground
with your right hand on the top
handle and your right knee resting
on the carburetor box cover.
To Next Page
Loading...
