31MS 192 T
English / USA
: Pull the starter grip slowly with your
left hand until you feel it engage –
and then give it a brisk strong pull
and push down the top handle at the
same time.
: Do not pull out starter rope all the
way because it might otherwise
break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.
When engine begins to fire
If engine is cold:
: Set the choke lever (5) to j and
continue cranking until the engine
runs.
If engine is warm:
: Continue cranking until the engine
runs.
As soon as the engine runs
: Blip the throttle trigger (3), the
Master Control lever (4) moves to
the run position # and the engine
settles down to idling speed.
.
As the chain brake is still engaged,
the engine must be returned to idle
speed immediately or the engine
housing and chain brake might
otherwise be damaged.
To Next Page
Loading...
