25MS 381
English
: Observe safety precautions – see
chapter on "Safety Precautions and
Working Techniques".
: Push hand guard (1) forward:
The chain is now locked.
: Press down the trigger interlock
lever (2) and pull the throttle
trigger (3) at the same time.
Set the Master Control to:
Position 4 if engine is cold.
Position 5 if engine is warm
(also use position 5 if the engine has
been running but is still cold)
: Place your saw on the ground.
: Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
Bystanders must be well clear of the
general work area of the saw.
: Hold the saw firmly on the ground
with your left hand on the front
handle – your thumb should be
under the handlebar.
: Put your right foot into the rear
handle and press down.
Alternative method of starting:
: Hold the rear handle tightly between
your legs, just above the knees.
: Hold the front handle firmly with
your left hand – your thumb should
be under the handlebar.
2
215BA002 KN
1
3
4
5
143BA018 KN
143BA019 KN
To Next Page
Loading...
Need help?
General
