27MS 381
English
At very low outside temperatures:
: Allow engine to warm up at part
throttle.
To shut down the engine:
: Move Master Control lever to c
If fuel tank has been run until dry
and then refueled:
: Press the button to open the
decompression valve.
: Pull starter rope several times until
fuel system is primed.
: Now start the engine.
If the engine does not start:
If you did not move the Master Control
lever to the "warm start" position quickly
enough after the engine began to fire,
the combustion chamber has flooded.
: Move Master Control (7) to run
position.
: Loosen knob (10) in direction of
arrow.
: Remove carburetor box cover (11).
: Pull off the spark plug boot.
: Unscrew and dry off the spark plug.
: Set the Master Control lever to c
: Press down the trigger interlock
lever – open the throttle wide and
crank the engine several times with
the starter to clear the combustion
chamber.
: Install the spark plug and connect
the spark plug boot (press it down
firmly) – reassemble the other
parts.
: Set the Master Control lever to the
warm start position – even if the
engine is cold.
: Press the button to open the
decompression valve.
: Now start the engine.
215BA004 KN
7
10
11
215BA005 KN
To Next Page
Loading...
Need help?
General
