Stihl MS 382 User Manual

damage the saw chain and cause dangerous
kickback.
Select suitable felling wedges dependent on the
trunk diameter and the width of the kerf (ana‐
logue to felling cut (E)).
Contact the STIHL dealer for the selection of the
felling wedge (suitable length, width and height).
4.6 Selecting the appropriate felling
cut
The selection of the appropriate felling cut is
dependent on the same tree characteristics that
must be noted when determining the direction of
fall and the escape paths.
There are various different features of these
characteristics. This User Manual will only
describe the two most commonly occurring var‐
iants:
001BA260 KN
left: Normal tree – vertically upright tree
with uniform crown
right: Leaner tree - crown pointing in direc‐
tion of fall
4.7 Felling cut with stabilizing strap
(normal tree)
A) Thin trunks
Implement this felling cut when the trunk diame‐
ter is smaller than the cutting length of the chain‐
saw.
001BA261 KN
1.
2.
Shout a warning before starting the felling cut.
► Plunge cut the felling cut (E) – plunge the
guide bar fully in
► Engage the spiked bumper behind the hinge
and use this as the rotation point – reposition
the chainsaw as little as possible
► Make the felling cut up to the hinge (1)
–
Do not cut into the hinge
► Make the felling cut up to the stabilizing
strap (2)
–
Do not cut into the stabilizing strap
001BA273 KN
3.
► Set the felling wedge (3)
Shout a second warning immediately before the
tree falls.
► Cut through the stabilizing strap, horizontal
level with the felling cut, with arms fully exten‐
ded
B) Thick trunks
Implement this felling cut when the trunk diame‐
ter is greater than the cutting length of the
machine.
001BA263 KN
4.
5.
1.
2.
3.
Shout a warning before starting the felling cut.
► Engage the spiked bumper at the height of the
felling cut and use this as the rotation point –
reposition the chainsaw as little as possible
► Tip of the guide bar must penetrate the wood
before the hinge (1) – guide the chainsaw
absolutely horizontally and swivel as widely as
possible
► Make the felling cut up to the hinge (2)
–
Do not cut into the hinge
4 Working Techniques English
0458-567-0121-B 13

Stihl MS 382 Specifications

General

Chain pitch	3/8"
Sound pressure level	106 dB(A)
Displacement	72.2 cc
Fuel Capacity	0.68 l
Fuel tank volume	0.68 L
Chain oil tank volume	0.36 L
Bar Length	40-50 cm