Stihl MS 382 User Manual

WARNING
Depth gauges that are too low increase the kick‐
back tendency of the chain saw.
689BA052 KN
► Lay the file gauge on the saw chain – the high‐
est point of the depth gauge must be flush with
the file gauge
► After sharpening, clean the saw chain thor‐
oughly, removing any filings or grinding dust –
lubricate the saw chain thoroughly
► In the event of extended periods of disuse,
store saw chains in cleaned and oiled condi‐
tion
Sharpening tools (special accessories)
Chain pitch Round file
^
Round file File holder File gauge Taper square
file
Sharpening
set
1)
Inches (mm) mm (Inches
)
Part number Part number Part number Part number Part number
1/4P (6.35) 3.2 (1/8) 5605 771
3206
5605 750
4300
0000 893
4005
0814 252
3356
5605 007
1000
1/4 (6.35) 4.0 (5/32) 5605 772 40065605 750 43271110 893 40000814 252 33565605 007
1027
3/8 P (9.32) 4.0 (5/32) 5605 772
4006
5605 750
4327
1110 893
4000
0814 252
3356
5605 007
1027
0.325 (8.25) 4.8 (3/16) 5605 772
4806
5605 750
4328
1110 893
4000
0814 252
3356
5605 007
1028
3/8 (9.32) 5.2 (13/64) 5605 772
5206
5605 750
4329
1110 893
4000
0814 252
3356
5605 007
1029
0.404 (10.26) 5.5 (7/32) 5605 772
5506
5605 750
4330
1106 893
4000
0814 252
3356
5605 007
1030
1)
consisting of file holder with round file, taper square file and file gauge
English 24 Maintaining and Sharpening the Saw Chain
34 0458-567-0121-B

Stihl MS 382 Specifications

General

Chain pitch	3/8"
Sound pressure level	106 dB(A)
Displacement	72.2 cc
Fuel Capacity	0.68 l
Fuel tank volume	0.68 L
Chain oil tank volume	0.36 L
Bar Length	40-50 cm