What to do if my Stihl Chainsaw switches off while I'm using it?
If your Stihl Chainsaw switches off during operation, the battery or machine electronics may be too hot. Remove the battery and allow both the battery and the machine to cool off. Alternatively, there may be an electrical malfunction. Try removing and reinserting the battery to resolve the issue.
What to do if Stihl MSA 160 C Chainsaw battery jams when being inserted in power tool / charger?
If your Stihl Chainsaw battery jams when being inserted into the power tool or charger, the guides or contacts might be dirty. Carefully clean the guides and contacts to resolve this issue.
Why does my Stihl MSA 160 C run time get too short?
There are a couple of reasons why your Stihl Chainsaw's run time might be too short: * The battery may not be fully charged. To resolve this, fully recharge the battery, referring to the User Manual for the STIHL AL 101, 300, 500 chargers. * The battery's life may have been exceeded, meaning it's time to replace the battery.
Why are 3 LEDs red on my Stihl Cordless Saw?
If 3 LEDs on your Stihl Cordless Saw are emitting red light, the chainsaw is too hot. Engage the chain brake, remove the battery, and allow the chainsaw to cool down.
Why does the LED on my Stihl MSA 160 C Chainsaw charger flash red?
If the LED on the charger flashes red when charging your Stihl Chainsaw battery, there might be a few reasons. First, check for electrical contact between the charger and the battery by removing and refitting the battery. If there's a malfunction in the battery (4 LEDs on the battery flash red for about 5 seconds), take the battery out and refit it. If the LEDs continue to flash, the battery needs to be replaced. A malfunction in the charger itself could also be the cause.
How to fix no electrical contact between my Stihl MSA 160 C and battery?
To fix the issue of no electrical contact between your Stihl chainsaw and its battery, engage the chain brake and remove the battery. Clean the electrical contacts in the battery compartment, then reinsert the battery.
Why is 1 LED red on my Stihl Cordless Saw?
If 1 LED on your Stihl Cordless Saw is emitting red light, the battery is either too warm or too cold. Engage the chain brake, remove the battery, and allow it to cool down or warm up to an acceptable temperature.
Why does my Stihl MSA 160 C have a smoke or burning smell?
If you notice smoke or a burning smell while using your Stihl chainsaw, several factors could be the cause. First, ensure that the chain is properly sharpened. If the chain oil tank is low, refill it. Also, check the chain tension and adjust if it's over-tensioned. If the chain lubrication system isn't working correctly, or you are not using the chainsaw properly, stop using the saw and seek assistance from your Stihl servicing dealer to prevent further issues.
Why is the running time too short on my Stihl Chainsaw?
There are several reasons why your Stihl Chainsaw's running time might be shorter than expected. The most common cause is an incompletely charged battery, so ensure the battery is fully charged before use. Also, a dirty cutting attachment can reduce running time, so keep it clean. The battery's service life may also be reached or exceeded, requiring a check and potential replacement.
What to do if my Stihl Chainsaw switches off during operation?
If your Stihl Chainsaw switches off during operation, it could be due to the battery or machine electronics overheating. Remove the battery and allow both the battery and the machine to cool down. Another potential cause is an electrical or electromagnetic malfunction. Try removing the battery and then reinserting it to see if this resolves the issue.
General| Voltage | 36 V |
|---|---|
| Bar Length | 12 in |
| Chain Gauge | 0.043 in |
| Power Source | Battery |
| Bar Length (cm) | 30 cm |
| STIHL Oilomatic saw chain type | Picco Micro 3 (PM3) |
| Sound Power Level | 96 dB(A) |
| Chain Pitch | 0.25 in |
| Recommended Battery | AP 300 |
| Recommended Charger | AL 300 |
To Next Page
