► Fill the water hose (1) with water so that no air
is present in the water hose any more.
► Screw the coupling (2) onto the connector of
the water filter (3) and tighten by hand.
► Attach the suction cup (4) to the water source
so that the suction cup (4) does not touch the
ground.
► If the spray gun is fitted to the high-pressure
hose: Remove the spray gun.
► Hold the high-pressure hose downwards.
► Switch on the high-pressure washer until an
even water jet flows out of the high-pressure
hose.
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure
hose.
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
9 Connecting the pressure
washer to the power supply
9.1 Connecting the pressure
washer to the power supply
► Turn rotary switch (1) to the 0 position.
► Open the flap (2).
► Swivel bracket (3) downward.
► Remove connecting cord (4).
► Place connecting cord (4) in the recess.
► Close flap (2).
► Plug the connecting cord (4) into a properly
installed socket.
10 Switching the pressure
washer on and off
10.1 Switch on high-pressure
washer
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavorable
mains conditions. The voltage fluctuations may
negatively affect other connected electrical appli‐
ances.
► Turn the rotary switch to the I position.
10.2 Switching off the pressure
washer
► Turn the rotary switch to the 0 position.
9 Connecting the pressure washer to the power supply English
0458-836-0121-A 15