Stihl RE 661 - User Manual

Questions and Answers:

L
Laura AlexanderAug 4, 2025
Why is my Stihl Pressure Washer motor humming but not running?
- C
  christophermelendezAug 4, 2025
  The Stihl Pressure Washer motor may hum but not run due to several reasons. Ensure the power cord is properly plugged into the wall socket and that the mains voltage is correct. Check the electrical connection, plug, cable, and switch for any issues. If you're using an extension cord, make sure it has a sufficient cross-section. Try connecting the machine directly without an extension cord. Also, the mains circuit-breaker might have been tripped. In that case, switch off the machine, actuate the spray gun until water only drips out of the head, engage the safety catch, and reset the mains circuit-breaker. Finally, make sure to actuate the spray gun when switching on the machine.
M
Michael MooreAug 8, 2025
Why does my Stihl RE 661 Pressure Washer have fluctuating pressure?
- T
  Thomas StaffordAug 8, 2025
  Fluctuating or dropping pressure in your Stihl Pressure Washer can be due to several factors. First, ensure a sufficient water supply by fully opening the water tap and using a 3/4" hose. Check if the high-pressure nozzle in the spray head is dirty and clean it if necessary. Also, the high-pressure nozzle might be worn and need replacement. Clean the screens in the intake of the water tank or high-pressure pump if they are clogged.
S
Scott ElliottAug 13, 2025
What to do if my Stihl RE 661 is not dispensing detergent?
- C
  Carla PhillipsAug 13, 2025
  If your Stihl Pressure Washer is not dispensing detergent, start by checking if the detergent tank is empty and fill it if needed. Inspect the detergent tank for any sludge and clean it. Ensure there is no air in the system by setting the detergent metering valve to the minimum setting, bleeding air out of the high-pressure pump, and checking the hose from the metering system to the water tank. Also, check the pick-up body for clogs and clean it. Finally, inspect the detergent intake for fouling or defects; clean or repair it as necessary.
M
Mrs. Heather WilliamsAug 17, 2025
Why does my Stihl RE 661 Pressure Washer run erratically?
- B
  bakerjenniferAug 17, 2025
  If your Stihl Pressure Washer is running erratically, it might be due to the high-pressure pump taking in air from an empty detergent tank. Set the detergent metering valve to the minimum setting and bleed air out of the high-pressure pump by removing the spray lance and operating the spray gun until the air has escaped.
J
Janet BarnettAug 22, 2025
What to do if my Stihl RE 661 Pressure Washer motor stops?
- P
  Paul HillAug 22, 2025
  If the motor of your Stihl Pressure Washer stops, it may be due to overheating. Check whether the supply voltage matches the machine's voltage. Allow the motor to cool down for at least 5 minutes.
A
adamsmaryAug 26, 2025
Why is the burner on my Stihl RE 661 clogged with soot?
- A
  acummingsAug 26, 2025
  If the burner on your Stihl Pressure Washer is clogged with soot, it could be due to contaminated fuel. Try using clean fuel.
K
Kevin CharlesAug 30, 2025
Why does my Stihl RE 661 Pressure Washer have a weak jet?
- R
  Roberto VaughnAug 30, 2025
  If your Stihl Pressure Washer has a weak, ragged, or unclean jet, it is possible that the high-pressure nozzle in the spray head is dirty. Clean the high-pressure nozzle.