0478-131-3045-A
55
English
15 Settings
Change PIN code
► Enter the old PIN code and confirm it by pressing the OK
button.
► Enter the new 4-digit PIN code and confirm it by pressing
the OK button.
Take note of your PIN code and keep it in a safe place. If the
PIN code is entered incorrectly 5 times, automatic operation
is switched off and can only be restored with a master code
generated by your authorized STIHL iMow servicing dealer.
Start signal
Alarm signal
Menu signal
Child lock
If the impact sensor is triggered several times in succession
within a short time, the robotic mower and the mowing blade
will stop.
If the impact sensor is not triggered again, the robotic mower
will continue automatic mowing after a few seconds.
Keylock
Link iMow and dock:
► Install the docking station and connect the perimeter wire,
@ 10.3 and @ 10.5.
► Lift the robotic mower slightly by the rear carrying
handle(1) and relieve the weight on the drive wheels.
Push the machine, resting on its front wheels, into the
docking station.
► After pressing the OK button, enter the PIN code.
The robotic mower will then search for the wire signal and
automatically save it for automatic operation. This process
may take several minutes, @ 10.6.
15.5 Service
Blade change
► After mounting a new mowing blade, confirm the
replacement of the mowing blade by pressing the OK
button.
Find wire break
► Activate the assistant to find a wire break by pressing the
OK button.
► Find the wire break, @ 21.3.
The 4-digit PIN code can be changed if necessary.
The "Change PIN code" menu item is only displayed
in the "Low," "Medium" or "High" settings.
The acoustic signal when the mowing blade is
activated.
The acoustic signal when the robotic mower hits an
obstacle.
The acoustic indicator when you open a menu and
confirm a selection by pressing the OK button.
When the keylock is activated, the operator must
press and hold the Back button and then press the
forward navigation button on the navigation pad to
unlock the control panel. The keylock will be
activated again 2 minutes after the last button is
pressed.
The mower and docking station must be linked if you
replace the docking station or the robotic mower.
1
0000-GXX-4398-A2
To Next Page
Loading...
Need help?
General
