Stihl RMI 632.1 - Page 79

EN
77
0478 131 8354 D - EN
– In the case of errors awarded the
priority "High", the text "Contact
your specialist dealer" appears on the
display.
The robotic mower can only be
operated again once the error has been
rectified by a STIHL specialist dealer.
Message:
0001 – Data updated
Press OK to release
Possible cause:
– Machine software has been updated
– Voltage loss
– Software or hardware error
Remedy:
– After the OK button is pressed, the
robotic mower operates with the default
settings – check and correct the
settings (date, time, mowing plan)
Message:
0100 – Battery discharged
Battery voltage too low
Possible cause:
– Battery voltage too low
Remedy:
– Place robotic mower in docking station
to recharge battery (Ö 15.8)
Message:
0180 – Temperature low
Main circuit board
Possible cause:
– Temperature inside robotic mower too
low
Remedy:
– Allow robotic mower to warm up
Message:
0181 – Temperature high
Main circuit board
Possible cause:
– Temperature inside robotic mower too
high
Remedy:
– Allow robotic mower to cool down
Message:
0183 – Temperature high
Charge control circuit board
Possible cause:
– Temperature inside robotic mower too
high
Remedy:
– Allow robotic mower to cool down
Message:
0185 – Temperature high
Drive control circuit board
Possible cause:
– Temperature inside robotic mower too
high
Remedy:
– Allow robotic mower to cool down
Message:
0186 – Temperature low
Battery
Possible cause:
– Battery temperature too low
Remedy:
– Allow robotic mower to warm up
Message:
0187 – Temperature high
Battery
Possible cause:
– Battery temperature too high
Remedy:
– Allow robotic mower to cool down
Message:
0302 – Drive motor fault
Temperature range exceeded
Possible cause:
– Temperature in left drive motor too high
Remedy:
– Allow robotic mower to cool down
If a message is still active despite
the proposed remedial action,
please contact your STIHL
specialist dealer.
Errors that can only be rectified by
a STIHL specialist dealer are not
listed in the following. Should an
error of this kind occur, please
communicate the 4-digit error code
and the error text to your specialist
dealer.
RMI 632 C, RMI 632 PC:
Messages that impair normal
operation are also reported to the
app. (Ö 10.)
The robotic mower enters standby
after the message is sent and
disables radio communication to
preserve the battery.