36 SR 430, SR 450
: Pull the throttle cable (1) out of
the guides (arrows).
– Press down the throttle lever until
the nipple (arrow) projects.
: Take the throttle cable (1) out of
the pin (2).
: Pull the protective tube (1) out of
the guides (arrows).
– Remove the control levers and
cam, b 8
– Remove the valve, b 10.9.2
0002RA086 TG
1
1
2
0002RA087 TG0002RA088 TG
1
: Pull the ground wire (1) off the
pin (arrow).
: Pull out the stop switch (2).
: Pull the ground and short circuit
wires out of the guides (arrows).
– Remove the wires with the stop
switch.
: Pull the protective tube (1) out of
its seat (arrow) in the handle
molding.
0002RA089 TG
1
2
0002RA090 TG0002RA091 TG
1
– Pull the wires and throttle cable
out of the guides.
The stop switch is permanently
connected to the short circuit wire.
If any part is damaged, the entire
throttle cable must be replaced.
Installing
: Push the stop switch (1) onto the
pins (arrows).
: Fit the ground wire terminal (1)
on the pin (2) with its crimped
side facing down.
0002RA092 TG
1
0002RA093 TG
1
2
To Next Page
Loading...
