SR 5600
English
9
Mounting the Control Handle
N Pull the ends of the clamp on the
control handle (1) apart and push it
over stub of pleated hose (2).
N Attach throttle cable to retainer on
the hose clamp (3).
Mounting the Extension Tube
N Rotate the pleated hose (1) as far
as stop.
N Swing control handle (2) to
horizontal position.
N Push the extension tube (3) into the
pleated hose (1) as far as it will go.
N The metering unit (4) must point in
the same direction as the control
handle.
N Tighten down the clamp screw (5) to
secure the control handle – see also
“Adjusting the Control Handle”.
Fitting the Liquid Hose
N Slip hose clip over the end of the
long hose.
N Push the liquid hose (1) onto the
container's stub and secure with a
hose clip.
N Secure the liquid hose (1) to the
pleated hose with retainer (2).
To Next Page
Loading...
