Stihl SR 5600 - Information Before Starting; Pre-Start Checks; Starting and Stopping the Engine; Engine Starting and Stopping Guide

SR 5600
English
13
NOTICE
With the engine stopped and before
starting, check the air intake grille
between the backplate and powerhead
for blockages and clean if necessary. A
protective screen is available as a
special accessory to keep the air intake
clear.
N Move the setting lever to the idel
position.
The throttle cable disconnects itself from
the throttle trigger if the engine is not
shut off in the idle position.
The throttle cable reconnects itself
automatically when the setting lever is
moved to the idle position.
Starting the Engine
N Observe safety precautions.
N Slide the stop switch (1) to #
N Move setting lever (2) to center
position – starting throttle.
The setting lever enables you to select
and hold any throttle position between
(lower stop) idle and full throttle (upper
stop).
Set the lever to the idle position before
switching off the engine.
Before Starting
N Close the stop cock (3) (set to
upright position).
Information Before You Start
373BA037 KN
Starting / Stopping the
Engine
373BA008 KN
1
373BA009 KN
2
3
0811BA011 KN